Garage Door Opener Installation In Couple Of Easy Steps

The procedure of garage door opener installation is usually simple, though manufacturers and parts may differ. Considering that these openers are typically installed by the customer, installation instructions are clear. Components are classified to make sure simple assembly. There is some companies providing garage door opener installation in Atlanta, GA but you need to choose the right one for better installation.

This process should only take a minimal quantity of time and your opener will certainly be totally operational.

Set up the Opener

Lay out all components as the guidelines show. Parts are normally stamped or could consist of lettered stickers. The very first step is to put together the rail. Next you will connect it to the opener’s electric motor head. When the opener has been totally constructed, the last action is installation.

Affix the Rail to the Header

To perform this action, you will require an 8-foot ladder. Increase your garage and mark it at the highest point. Close the garage door.

At the site of the mark, measure up two inches. The bottom of the header brace will be put right here, over the center of the door. Place the header bracket on at the 2nd mark and secure it with 2 wooden lag bolts.

With the motor end on the flooring and the rail inside the header bracket, align the opener setting up on the door. You will should line up the holes on the rail with the header bracket. Glide a clevis pin through the brace and rail to connect.

Mount the Electric motor

Area the ladder at the rear of the door tracks, in the facility. Place the electric motor on the ladder. Gradually, increase the garage door until it is available in contact with the door. As you continuously open the door, the electric motor setting up will be taken off the electric motor. When the door is totally open, put a 2×4 in between the opener rail and the door.

To do your garage door opener installation correct, you will should secure the hangers to the motor head right into the ceiling packs. Using the guidelines and hangers supplied, connect them to the ceiling with lag bolts. After attaching the hangers, lift the motor head and bolt it to the ceiling wall mounts.